The Challenger ZSA10-IOM-A installation and operation manual is the direct replacement for the Challenger lift it came off of. This is the genuine Challenger part — same fit and same working specification as the one already on your lift. Ordering the Challenger installation and operation manual from us gets you the OEM piece that matches the lift, not an aftermarket knock-off that is close but not the same.

Specifications

• Part number: ZSA10-IOM-A
• Brand: Challenger
• Type: Genuine OEM installation and operation manual

On lifts that use air — for lock release or pneumatic engagement — the air supply is part of the safety system, not an accessory. A compressor or regulator that can't hold steady pressure means the locks don't actuate the way they're supposed to. The air side is simple, but it has one job that matters: deliver clean, regulated pressure on demand so the lock mechanism does exactly what the operator asks.

Replacing your installation and operation manual

Sorting out the air supply — compressor, regulator, moisture trap — is about delivering clean, steady pressure to the lock system on demand. Set the regulator, drain the trap, and confirm the pressure holds while the locks cycle. The step-by-step guide lays out the settings and checks. Not sure on the procedure? Find your lift in our parts lookup or call and we will walk you through it.

Find the right part for your lift

Want to be sure before you buy? Pull the model and serial off your lift's plate and open our Challenger parts lookup to open the exploded parts breakdown for your model — find your part on the drawing and you know it fits. New to finding your model number? our guide to finding your model number covers it, or send a photo of the plate and we will read it for you.

Signs it's time to replace it

For airlines, run the length looking for cracks, kinks, chafe points, and oil-swollen or brittle sections. Check every push-connect and threaded fitting for leaks — a quick spray of soapy water shows bubbles at a leak. Pull the lock release and confirm air actuates the pawls promptly; a soft, slow, or uneven release points to a leaking line, a bad fitting, or low supply pressure.

Parts commonly replaced at the same time

Since you are already ordering, tell us your lift and we will point out what else it commonly needs — related hardware, safety labeling, accessories rated for your model. Consolidating into one order is cheaper and simpler than piecing it together over several. We keep the breakdown for your lift on hand.

Safety notes

The little parts round out a safe, compliant lift. Use the correct component for your model, keep the required labeling in place and readable, and follow the manufacturer's install notes. If you are not sure which version your lift takes, a quick call saves a wrong order and a second trip up the ladder.

Before you order

Before ordering, confirm your lift's model and serial so we can match the correct version — even simple parts have revisions. If you are replacing a decal set or an accessory, tell us the model and we will make sure you get the one specified for your lift rather than a near-miss.

Not sure this fits? Here's how to check

Pull the number off your lift's model plate first — model and serial both. Manufacturers run mid-cycle revisions that keep the model name but change hardware, so two lifts with the same name on the column can take different parts. The serial is what removes the guesswork.

Second check: compare the old part against this listing before you order. Length, mounting pattern, and thread sizes tell most of the story. If anything doesn't line up, or if the old part is too worn or broken to measure, call us with photos — we work on these lifts every week and can usually confirm fit from a picture and the lift's serial faster than you can dig through a parts diagram.

Why buy your Challenger installation and operation manual from Auto Lift Services

We install, inspect, and repair Challenger lifts every week — the ZSA10-IOM-A is a part we handle in the shop, not a random SKU we drop-ship. The phone answers if you have a question mid-install — call 800-674-9302 — and every part ships genuine, no aftermarket substitution unless you ask for it.