The Rotary FJ6115 lift adapter is the direct replacement for the Rotary lift it came off of. This is the genuine Rotary part — same fit and same working specification as the one already on your lift. Ordering the Rotary lift adapter from us gets you the OEM piece that matches the lift, not an aftermarket knock-off that is close but not the same.

Specifications

• Part number: FJ6115
• Brand: Rotary
• Type: Genuine OEM lift adapter

Adapters take a beating because they're the parts techs handle every day — stacked, swapped, dropped, and driven over. A bent lip, a mushroomed top, or a cracked weld on a frame-cradle adapter comes from that daily handling as much as from load. Because they're small and get tossed in a pile, they're easy to grab without a second look — which is exactly how a bent one ends up under a car.

Replacing your lift adapter

Replacing column hardware — anchors, arm-pin retainers, slide blocks, fasteners — is about restoring the tight, no-play fit the structure was built with. Use the correct grade and torque, and confirm the column sits flat and solid to the floor afterward. The complete procedure lays out what to check and in what order. Not sure on the procedure? Find your lift in our parts lookup or call and we will walk you through it.

Find the right part for your lift

The surest way to get the right part is to work from your lift's own breakdown. open our Rotary parts lookup, choose your model, and every part is mapped on the drawing with its number and price. If you cannot find the model plate, our guide to finding your model number explains where each lift type hides it, and our phone line is open if you want a hand.

Signs this part is worn out

Start with the pads. A good pad is thick, square, and grippy; a worn one is crushed flat, cracked through, torn at the edge, or hardened smooth so it no longer bites. If a pad is missing chunks, oil-soaked, or compressed past half its original height, replace it — a slick or crushed pad lets the vehicle's lift point slide right off the arm.

Parts commonly replaced at the same time

Smart to replace the group: contact points wear together, so pads, adapters, and their pins are best done in one pass. It keeps the lift level and the vehicle secure. We will build the matched structural kit for your model so you are not chasing one worn pad at a time.

Safety notes

Structural wear sneaks up: a pad flattens, a hole elongates, a ramp lip curls, and one day the vehicle is not sitting where it should. Treat these as safety parts, not cosmetics. Replace them before they let a load shift, and confirm every mounting point is tight and true before the lift carries weight.

Before you order

Before ordering, confirm your lift's model and serial and check how many of the part you need — pads and adapters usually go in sets of four, and replacing one worn one still leaves three worn. Match the old part's shape and mounting against what you order, and call if the fit is not obvious.

Not sure this fits? Here's how to check

Pull the number off your lift's model plate first — model and serial both. Manufacturers run mid-cycle revisions that keep the model name but change hardware, so two lifts with the same name on the column can take different parts. The serial is what removes the guesswork.

Second check: compare the old part against this listing before you order. Length, mounting pattern, and thread sizes tell most of the story. If anything doesn't line up, or if the old part is too worn or broken to measure, call us with photos — we work on these lifts every week and can usually confirm fit from a picture and the lift's serial faster than you can dig through a parts diagram.

Why buy your Rotary lift adapter from Auto Lift Services

We install, inspect, and repair Rotary lifts every week — the FJ6115 is a part we handle in the shop, not a random SKU we drop-ship. The phone answers if you have a question mid-install — call 800-674-9302 — and every part ships genuine, no aftermarket substitution unless you ask for it.